Carry out perming wearing protective gloves.
Treatment not recommended for hair coloured with dyes containing ammonia.
Do not use Goldwell Vitensity products individually, but only as part of a complete permanent service, consisting of lotion + fixing.
1.Shampoo with a Goldwell mild shampoo.
Do not massage the scalp to avoid sensitising the skin.
Rinse, then towel-dry the hair.
2. In the case of sensitive, stressed, porous hair, spray Goldwell System Pre-Curl on the damaged areas to even out the structure. Do not rinse out.
3. Roll the curlers over damp hair.
4. Permanent: apply Goldwell Vitensity Perming Lotion. Recommended quantities:
- 60ml for short hair
- 80ml for medium length hair
- 100ml for long hair
Wet each curler 2-3 times with the lotion until saturated.
Avoid wetting the scalp with the lotion.
5. Laying times
with infrared heat source: 10-20 min
room temperature (with plastic cap and towel): 15-25 min
6. After the minimum laying time, remove a curler. If the resulting curl is not satisfactory, rewind the curler and repeat this test every 3 minutes until the desired result or maximum setting time is achieved.
7. Rinse thoroughly for a few minutes without removing the curlers, then towel-dry hair thoroughly.
8. Apply Goldwell System Inter-Curl to improve the performance, hold and durability of the perm. Saturate each curler with Inter-Curl, leave on for 3 minutes and fix without rinsing.
9. Fixing: dilute Goldwell Vitensity Gloss Care Fix Neutralising Concentrate in equal parts water (e.g. 50ml water + 50ml Gloss Care Fix for short to medium hair). Distribute about 2/3 of the solution with a sponge on hair still wrapped in curlers. Leave on for 5 minutes without rinsing.
10. Gently remove the curlers and do a post-fixing by distributing the remaining fixing solution over the lengths and ends. Leave on for 3 to 5 minutes.
11. Rinse thoroughly, then gently pat dry without rubbing the hair.
12. Use the Goldwell Dualsenses Curly twist range to keep curly hair looking vibrant.